Cadenza ribbon microphones are quite common, but there seem to be more microphones than there are connectors for them. The mics were originally supplied with an integrated stand & connector, which was ideal for desk recording, but not very effective for hanging over a drum kit.
This mic was missing its connector, so here is a chop-job to convert to XLR output….
The connector was removed from the mic and the bottom thread cut off and filed flat. Then a piece of brass rod was machined to fit snugly into the base of the mic, and this was bored to accept a standard three pin XLR insert.
The XLR has the added advantages of making a good earth connection, and also gives a way of mounting the mic on a stand as it can be slipped into a standard mic clip. I think elongating the base makes the look more elegant too.
